![]() ![]() I can get each nail out in about 10-15 seconds doing this. To remove the nails I used some combination pliers to push the nail up a bit, and then some diagonal pliers to twist and pull the nail out. If you do want to reuse them then I’ve found it is easier to remove the fixing nails and then use new nails/screws to secure them. New carpet grippers are really cheap so it is probably less hassle to buy new ones than to attempt to reuse them. It is even possible to reuse the carpet grippers after they have been removed using this method, but because the nails are now pushed down, and slightly curved after being removed they are a bit arkward to hammer back down. I was able to remove the grippers pretty quickly, and intact using this method. I found that on a strip of carpet gripper the first nail might take about 5 seconds to get out, but then the next ones might take 2-3 seconds. In all cases I was able to push the end of the chisel under the gripper a little by hand, and then work the nail out. If the gripper is really tight on the floor board you might need to hammer the chisel gently to get it below the gripper, but I never needed to do this. The using the other chisel as a fulcrum I slowly levered the nail out. The method I used was to start at one end of a carpet gripper machine and push the sharp end of the chisel under the first nail. I’ve had some that have shot up well above the height of my face when they suddenly pop out of the floor. They are covered in sharp nails, and they can fly off the floor when levered up. ![]() In this case you really should – especially when removing smaller strips of carpet gripper. A lot of DIY guides say to use safety glasses but of course you never do. I used a smaller chisel but I could have used anything of similar size and solid such as a screwdriver or piece of wood or metal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |